Wire Cable Pulling Grips
Staggered lengths for easier movement Each set includes six grips for pulling one or more cables through conduit.
No cutting, stripping or weaving of wire to make pulling head;
Wire cable pulling grips. Use them to pull one or more cables through conduit. Pulling grips are indispensable in many different cable pulling applications. Each double lock maxis® grips® head rated at 4000 lbs.
Hand woven galvanised steel wire mesh with two pulling eyelets and talurit wire rope clamp, wire breaking strenghth 200 kg/mm². This version of internet explorer is either no longer supported by microsoft , or is obsolete and some features of our store may no longer be supported. Pulling grips form lewis mfg are wire mesh grips used for power & fiber optics cables, wire ropes and stress free suspension of cables.
Benefits are derived from well implemented solutions. Pull wire and cable while maintaining tension until the line can be permanently anchored. Eaton’s complete offering of arrow hart wire mesh grips is built tough for industrial applications.
These grips have a flexible pulling loop that allows you to pull at an angle. Cable pulling grips and grip kits are mesh tubes that are placed over cable so it can be pulled through long runs of conduit and trenches. Disconnect wire from pulling heads in 2 minutes without cutting the wire;
They have a wide range of applications in manufacturing, agriculture and bridge construction. Wire and cable pulling clamps. The challenge to save energy, improve security or make sure everything continues to perform in a harsh environment, are all candidates for good solutions.
Pull one or more cables through conduit. The profile of the clamping jaws is specifically designed for copper and steel cables so that the stretched material does not become damaged. The greater the pulling force, the tighter the wire mesh grips your cable.
Getting the cable from point a to point b without snagging and damaging it. Grips and cable pulling tools. Havens grip for wire rope the klein tools 1625 series wire rope havens the klein tools 1625 series wire rope havens grips are designed for use when a light, compact grip is desired and where cable deformation is not a factor.
A wide variety of styles are available to suit your specific application. Usually constructed of stainless or galvanized steel, grips let contractors pull cable reliably in a variety of applications. Southwire's flexible leader guides steel tapes through conduit and helps reduce the challenge of pulling wire and cable.
Whether they are pulling cable through conduit or stringing it with overhead transmission lines, contractors face a basic challenge: 14 to determine the cable diameter range you need. Easily moves through conduit and around 90° bends;
Pulling grips from automation direct: Cord grips, cable grips and industrial wiring products at discount prices. Each set includes six grips.
Cable pulling grips with two reinforced pulling eylets, lateral opening with two wires for later interlacing. Also known as cable socks, the mesh is secured around the cable with clamps or tape, and the rings or eyes at the end of the grip are pulled to tighten it around the cable. The broad selection of strain relief, pulling, and support grips are available in a wide range of styles and sizes to serve all of your cable protection needs.
These wire grips are the ideal tool to safely stretch copper and steel cables. Pulling grips overhead type are used for cable and wire rope pulling and installation of them overhead on the transmission lines. Underground pulling grips are available for pulling cables and duct through conduit, plowing or directional boring.
For more than one cable, measure the circumference of the bundle and divide by 3.